Andersen Frenchwood 2 panel gliding door reach out lock assembly and latch receiver assembly kit. For doors manufactured 1994 to present. Installs into the door panel and hooks into the receiver installed on the door jamb, pulls the door closed and locks the door This kit is used on all 2 panel doors with reachout hardware regardless of the finish of the other hardware parts. Includes reach out lock assembly, latch receiver, and installation screws/ bolts. Note: Lock assembly is often referred to as dead bolt, and latch receiver is often referred to as strike plate. Works With following doors: 200 Series Narroline Gliding 200 Series Perma-Shield Gliding 400 Series Frenchwood Gliding To check the Lock Adjustment 1. Open the door and operate the lock from inside with the thumb turn – it should move smoothly 2. Close the door and lock – Does the thumb latch still work smoothly? If Not, the lock or strike may need adjustment Pre-Reach Out Locks The older Andersen locks had the adjustment in the face of the lock. When the screw is turned it would move the latch in or out for better adjustment If the lock thumb latch is hard to turn – extend the latch, if the door has to much movement – retract Turn clockwise to retract latch Turn counter-clockwise to extend Reach Out Locks Same idea as above, except Andersen moved the adjustment to the Strike plate on door jamb Some doors may have adjustment on Lock and strike. The item “Anderson Sliding Glass Door Lock Latch & Reciever Assembly Kit” is in sale since Saturday, March 23, 2019. This item is in the category “Home & Garden\Home Improvement\Building & Hardware\Doors & Door Hardware\Doors”. The seller is “locksmithsecurity” and is located in Brentwood, New York. This item can be shipped to United States.